8-198 Section 8-9 - Operating System and Application Software Loading Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
The Warning message appears:
5.) Click Yes in the Warning message box.
6.) Automatic installation process runs. At the end of the process, the following message appears:
7.) Click Reboot Venue Scanner. Wait until the INFORMATION dialog box appears:
8.) Disconnect the SW installation media and tap OK in the message box.
9.) In the Confirmation dialog box that appears, tap Yes to continue the reboot.:
10.)Tap Yes to continue the reboot.
11.)After the system reboots, the Venue™ setup wizard welcome screen appears:
Figure 8-237 Venue™ Partition C - Warning Message
IMPORTANT Venue R1 user presets are not compatible with R2 software. The backed up presets can
only be used if reverting back to R1 software version. Do not try to import these presets to R2 software.
Figure 8-238 Venue™ Installation Process- Information Dialog Box
Figure 8-239 Venue™ Installation Process- Confirmation Dialog Box
To Next Page
Loading...
