General Information GEDA
®
MINI 60 S / MAXI 120 S / MAXI 150 S
Assembly and Operating Manual 10 / 90 BL068 GB Edition 03/2015
1.7 Intended use
The scaffolding lift GEDA MINI 60 S and GEDA MAXI 120 S/150 S is
a temporary hoist installation erected and
• which is intended exclusively for putting up scaffolding and for trans-
porting items and materials during construction work.
• which may only be operated at a wind speed of up to 72 km/s
(20 m/sec. ≈ wind force 7-8 according to the Beaufort scale).
− which must have its load parked on the ground and the rope winch
taken out of operation at higher wind speeds.
Observe and comply with the instructions in Chapter 3.5, “Technical
specifications”.
Any other use or any use (e.g. transportation of persons) going beyond
this is not considered intended use.
The operating company / user of the machine is solely liable for
any damage resulting from such action. This applies equally to any arbi-
trary changes to the machine.
Intended use includes
− That the assembly, operation and maintenance provisions (assembly
and operating manual) provided by the manufacturer are complied
with.
− That the foreseeable misconduct of other persons is taken into con-
sideration.
− That the corresponding national regulations are complied with.
The GEDA MINI 60 S and GEDA MAXI 120 S/150 S is suitable for
temporary use on construction sites. Any other locations or in-
tended uses require written approval from the manufacturer.
To Next Page
Loading...
