GEDA MINI 60 S - Universal Pivot Arm for the GEDA MAXI 120 S;150 S

GEDA
®
MINI 60 S / MAXI 120 S / MAXI 150 S Assembly
BL068 GB Edition 03/2015 51 / 90 Assembly and Operating Manual
5.3.2.3 Universal pivot arm for the GEDA MAXI 120 S/150 S
Universal pivot arm comprising of
- Pivot arm with reinforcing Item No. 05711 and
- Pivot arm mounting for load capacity 150 kg Item No. 29197
WARNING
Danger to life
Only use pivot arm with reinforcement (refer to the stamp on the
pivot arm max. load capacity 150 kg).
Only use pivot arm mounting for load capacity 150 kg (refer plate
on the pivot arm mounting).
The pivot arm mounting serves for fastening the pivot arm between
scaffolding levels.
 Attach the pivot arm mounting (6)
for the MAXI 120 S/150 S (with
adjustable attachment at the top)
to the vertical pipe (4) so that it
points outwards from the scaf-
folding
 Place the pivot arm (3) and se-
cure by fully tightening the star
handle (3a).
The upper fastener of the pivot arm
mounting is adjustable so that it can
be adjusted in height in order to be
able to swing inward the pivot arm
(3) within the above scaffolding lev-
el.

It must be ensured that both fasteners of the pivot arm mounting
are fastened as closely as possible to the intersections of the scaf-
folding.

The vertical frame (4), on which the pivot arm mounting with pivot
arm is suspended, must be anchored above and below to the
building (tensile and compression proof anchor) and additionally
secured with cross stays.
Anchoring forces = minimum 1.5 kN [0.34 kip]
3
4
3a
6