page | 122
Commands
#set_low_power
If the Multi-Format Processor will be controlled via the Web interface or via IP commands,
then param1 must be set to 1. This setting turns off the Ethernet port is turned off when
the Multi-Format Processor is placed in standby mode (Power LED indicator on front panel
is red) in order to reduce power consumption. Turning off the Ethernet port will reduce
power consumption to under 0.5W but will not allow the Multi-Format Processor to be
turned on using IP control or the Web interface.
0 - RS-232/IR / Front Panel Only (Power Consumption < 0.5W)
1 - IP Control / RS-232 / IR / Front Panel (Power Consumption > 0.5W)
Syntax
#set_low_power param1
Parameters
param1 Integer [0 ... 1]
param1 Description
0
Off
1
On
Examples
#set_low_power 1
LOW POWER STANDBY IP IS SET TO ON
#set_low_power 0
LOW POWER STANDBY IP IS SET TO OFF
Related Commands
#get_power
Advanced Operation
Advanced Operation
To Next Page
Loading...