Gefen EXT-MFP - Page 193

page | 183
Advanced Operation
Commands
#set_edid
Sets the type of EDID to be used by the Multi-Format Processor. The argument for param2
is dependent upon the value of param1. The argument for param4 is dependent upon the
value of param3.
Syntax
#set_edid param1 param2 param3 param4
Parameters
param1 Source type
param1 Description
INT
Internal EDID
BANK
EDID Bank
INPUT
HDMI / DP / DVI / VGA Input
OUTPUT
HDMI / DVI Output
param2 Source
param2 Description
0 ... 7
Internal EDID *
(param1 must be INT)
1 ... 8
EDID Bank
(param1 must be BANK)
HDMI
DP
DVI
VGA
EDID from Input
(param1 must be INPUT)
HDMI
DVI
EDID from Display
(param1 must be OUTPUT)
* See next page for Internal EDID descriptions.
(continued on next page)