Gefen EXT-MFP - Page 61

page | 51
4. Press the ▲ or ▼ buttons to highlight the Under/Over Scan option.
5. Press the OK button, again, to activate the Under/Over Scan option.
6. The current value will highlighted in red.
7. Press the ▲, ▼, ◄, or ► buttons to set the desired setting.
► Off
No underscan / overscan applied. This is the default setting.
► Under1, Under2, Under3
Applies underscan values of 3%, 6%, and 9% respectively.
► Over1, Over2, Over3
Applies overscan values of 3%, 6%, and 9% respectively.
Auto Size
Phase 040
V Position 005
H Position 054
Under/Over Scan Off
Aspect Ratio Source
HDCP
Send HPD Pulse ---
Back
VGA Settings
Auto Size
Phase 040
V Position 005
H Position 054
Under/Over Scan Over2
Aspect Ratio Source
HDCP
Send HPD Pulse ---
Back
VGA Settings
®
RMT-MFP
OK
Resolution
Menu
Exit
L/R 1
Int
VGA
HDMI
Off On
DP DVI
Comp Mask
Optical Coaxial
L/R 2 Mute
Info
Vol -
Vol +
Aspect Ratio
Audio
Video
*Preferred
Basic OperationBasic Operation
Menu System