page | 21
Increasing / Decreasing Volume
Use the included IR remote to adjust the output volume.
1. Press the Volume button on the IR remote. This will cause all the output buttons (A,
B, C, D), on the front panel of the matrix, to start ashing.
2. Press the desired output button on the IR remote to affect the volume control of the
output. The associated output button, on the front panel of the matrix, will begin to
ash.
3. Adjust the volume by pressing the Up or Dn buttons on the IR remote.
4. The front-panel input LED indicators will provide a specic response, depending upon
whether the Up or Dn button is pressed, as described on the following page.
Basic OperationBasic Operation
Volume Control
Information
If the output volume mode is set to xed, then the operation will be
immediately cancelled.
Output
RMT-44A
Down
Up
OFF1
3
Input
4
2
Preset
Mask
Lock
A B
C D
Mute
Volume
Volume button
Output buttons
Up / Dn buttons
To Next Page
Loading...
Need help?
General
