page | 6
Installing the Batteries
1. Remove the back cover the IR remote control unit.
2. Insert two 1.5V AAA-type batteries, as shown, within the battery compartment.
3. Replace the back cover.
Getting Started
Introduction
Warning!
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Output
RMT-44A
Down
Up
OFF1
3
Input
4
2
Preset
Mask
Lock
A B
C D
Mute
Volume
R03,1.5V
R03,1.5V
ON
1 2
_
+
_
+
Getting Started
To Next Page
Loading...
Need help?
General
