page | 73
Advanced Operation
Commands
Command Description
#get_audio_output
Returns the audio mode for the specied output(s)
#get_input_hdcp
Returns the HDCP handshake more on an input
#get_io_name
Returns the name of the specied input
#get_output_hdcp
Returns the HDCP setting of the specied output
#get_video_scaling
Returns the scaling setting for the specied output
#send_hpd
Sends an HPD signal to the specied input
#set_audio_output
Sets analog audio mode for the specied output(s)
#set_input_hdcp
Sets the HDCP setting on the specied input
#set_io_name
Sets the name of the specied input or output
#set_output_hdcp
Sets the HDCP setting on the specied output
#set_video_scaling
Sets the scaling state for the specied output
Command Description
#factory_reset
Resets the matrix to factory-default settings
#get_button_brightness
Returns the current button brightness value
#get_feedback
Returns the feedback state
#get_rmware_version
Returns the current version of matrix rmare
#get_ir_channel
Returns the current IR channel on the matrix
#get_led_brightness
Returns the current LED brightness setting
#help
Returns a list of available commands
#reboot
Reboots the matrix
#set_button_brightness
Sets the brightness level of the front-panel buttons
#set_feedback
Enables or disables unsolicited RS-232 feedback
#set_ir_channel
Sets the IR channel of the matrix
#set_led_brightness
Sets the brightness of the LED indicators
Command Description
#get_mute
Returns the muting status for the specied output(s)
#get_vol
Returns the analog output volume for the output(s)
#set_mute
Sets the audio muting for the specied output(s)
#set_vol
Sets the analog output volume for the output(s)
Setup
System Settings
Volume
To Next Page
Loading...
Need help?
General
