Rev. 00 02/21
76
Maintenance / Repairs OptiCenter OC09
29. The automatic process step is complete once this symbol is
displayed.
– The key can be pressed once again if necessary. Otherwise, the
next cleaning step can be activated.
30. Press the key
– The existing OptiFeed pumps and connected powder hoses are
cleaned and the powder is transported to the after filter
31. The process is complete once this symbol is displayed.
Any individual step can be repeated as needed by pressing the
corresponding key again.
– Only the selected cleaning step is carried out.
Fine cleaning
1. Press the key
– This key activates/deactivates the strong fluidization for fine
cleaning
2. Press the key
– This key is used to activate/deactivate the suction unit
3. Visually check the OptiHopper interior, clean with the suction unit
and/or with the compressed air gun if necessary
4. Put the plug back in position
5. Place the cover components in position
6. Booth cleaning can now be started: Activate the corresponding
command on the MagicControl control unit
To Next Page
Loading...
