Rev. 00 02/21
OptiCenter OC09 Maintenance / Repairs
75
– The powder from the OptiHopper flows into the powder bag or
provided powder container
25. Use a scraper to lead as much powder as possible to the opening
26. Use a scraper to clean the side walls of the OptiHopper so that the
suction openings are no longer covered with powder.
27. Also clean the fluidizing plate so that there is only a small amount of
powder on the surface.
28. Press the key
– The powder hoses are cleaned and the residual is transported to
the booth
– Suction channels in the OptiHopper are rinsed
To Next Page
Loading...
