General Dynamics URC-200 (V2) - Page 63

General Dynamics C4 Systems URC-200 (V2)
53
Table 11 – Remote Transceiver Operation Commands (Continued)
CODE NAME DESCRIPTION
EQUIVALENT
TRANSCEIVER
KEYPAD
COMMAND
T
Note 1
Transmit
Frequency
The “T” Command sets the transmit
frequency value for the current preset
channel.
The “T” Command followed by 6 digits
defines a transmit frequency value. The 7
th
digit is automatically determined by the
transceiver. The ‘x’ values, along with the
7
th
digit, must be divisible by 25 kHz, 12.5
kHz, or 5 kHz.
"Txxxxxx" = transmit frequency
Transceivers with the EBN-30 Option, for
the 30-90 MHz band, the first digit
following the “T” Command will be a "0"
which is then followed by 5 digits to define
the transmit frequency value. The 7
th
digit
is automatically determined by the
transceiver. The ‘x’ values, along with the
7
th
digit, must be divisible by 25 kHz or
12.5 kHz.
“T0xxxxx” = transmit frequency for the
30-90 Band
Transceivers with the EBN-400 Option, for
the 400-420 MHz band, the first digit
following the “T” Command will be a "4"
which is then followed by 5 digits to define
the transmit frequency value. The 7
th
digit
is automatically determined by the
transceiver. The ‘x’ values, along with the
7
th
digit, must be divisible by 25 kHz, 12.5
kHz, or 5 kHz.
“T4xxxxx” = transmit frequency for the
400-420 Band
R/T
←
BCN
1
FREQ
0 – 9
XXX
(ENTER 6 DIGITS)
(See Paragraphs 4.4.6.2
and 4.4.6.5)