66
As an additional precautionary measure to prevent formation of moisture in the Battery Compartment, it is recommended that
the Battery be changed in an environment equivalent to the local outdoor temperature and humidity (e.g., do not change the
Battery in an air conditioned environment, then take it outside during a hot sunny day).
• Inspect the Buttons, Lens, and Housing to ensure they are not cracked or damaged.
• If there is any sign of moisture in the module, DO NOT use the ReACT Pro until it receives proper service by an Autho-
rized Genesis Scuba Dealer.
WARNING: If damage, moisture, or corrosion is found, it is recommended that you return your
ReACT Pro to an Authorized Genesis Scuba Dealer, and DO NOT attempt to use it until it has
received factory prescribed service.
NOTE: If the old battery can be removed and the new one inserted within 8 seconds, nitrogen and
oxygen calculations ,and settings, will be retained for repetitive dives.
Battery Hatch Removal
• Locate the Battery Compartment on the back of the unit.
• While applying steady inward pressure on the center of the Battery Hatch, rotate the Hatch Re-
taining Ring 10 degrees clockwise by pressing against the upper tab of the Retaining Ring with
a small blade screwdriver (Fig. 65).
• Lift the Hatch Ring up and away from the Housing, or turn the module over to allow the Ring to
drop out into your hand.
• Remove the Battery Hatch.
N
Fig. 65 - Hatch Ring Removal
To Next Page
Loading...
Need help?
General
