69
ReACT Pro
Inspection
• Activate the unit and watch carefully as it performs a full diagnostic and battery check, and
enters Surface Mode. Observe the LCD display to ensure it is consistently clear and sharp
in contrast throughout the screen.
WARNING: If there are any portions of the display missing or appearing
dim, or if a Low Battery condition is indicated, return your ReACT Pro to an
Authorized Genesis Scuba Dealer for a complete evaluation before
attempting to use it.
RETURNING THE MODULE TO BOOT
• If the Boot was fitted with a Spacer and it was previously removed, replace the Spacer into
the Boot.
• Orient the Module over the opening in the Boot, and dip the bottom edge into it while
pressing the top edge with the palm of your hand. Stop pressing when the bottom edge of
the Module has just entered the Boot.
• Correct the alignment of the Module as needed so that it is straight.
• Press the Module completely into place with your thumbs, watching the alignment, until it
snaps into place.
R
E
S
P
O
N
S
I
B
L
E
D
I
V
E
R
To Next Page
Loading...
Need help?
General
