Genie Z Series User Manual

April 2018
Table of Contents
xii S
®
Booms • Z
®
Booms Part No. 1268489GT
Annual Maintenance Procedures ................................................................... 101
A-1 Grease the Turntable Rotation Bearing and Rotate Gear ........................... 101
A-2 Check the Turntable Rotation Bearing Bolts ............................................... 102
A-3 Inspect for Turntable Bearing Wear ............................................................ 103
A-4 Check the Extendable Axle - S-100, S-105, S-120 and S-125 ................... 104
A-5 Perform Maintenance- Jib Rotate Bearing ................................................. 105
A-6 Test the Bypass/Recovery Key Switch - ALC1000 Models ........................ 106
A-7 Grease the Platform Overload Mechanism (if equipped) ............................ 108
A-8 Test the Platform Overload System -
All Models, Except ALC1000 and S-60HC Models .................................... 109
A-9 Test the Platform Overload System - ALC1000 Models ............................. 111
A-10 Test the Platform Load Sense System - S-60 HC..................................... 112
A-11 Inspect the Boom Extend/Retract Cables - S-60 and S-80 Models .......... 113
A-12 Inspect the Boom Extend/Retract Cables -
S-100, S-105, S-120, S-125, SX-105 XC and SX-125 XC ........................ 115
A-13 Inspect the Boom Extend and Retract Cables -
SX-135 XC, SX-150 and SX-180 ............................................................... 117
A-14 Check the Drive Hub Oil Level and Fastener Torque ............................... 121
A-15 Test the Dual Capacity and Platform Overload System -
SX-105 XC, SX-125 XC and SX-135 XC ................................................... 123
A-16 Test the Dual Capacity and Platform Overload System -
Z-45 XC Models ......................................................................................... 125
A-17 Test the Dual Capacity and Platform Overload System -
S-80 XC and SX-85 XC .............................................................................. 126

Genie Z Series Specifications

General

Lift Capacity	500 lb (227 kg) to 660 lb (300 kg)
Gradeability	30%
Power Source	Diesel, Electric
Capacity	500 lb (227 kg) to 1, 000 lb (454 kg)
Drive System	4-wheel drive
Tire Type	Solid
Steering	2-wheel or 4-wheel