VRC2000 Installation and Operations Manual Page 13
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
Step 2
In order to change the access codes for all three security levels, enter
☎ “0 9 0”
The VRC2000 will respond:
• OPERATOR ACCESS CODE IS {0, 1, 2, 3, 4} ... [BEEP]
• USER ACCESS CODE IS {1, 2, 3, 4, 5} ... [BEEP]
• SYSTEM ACCESS CODE IS {1, 2, 3, 4, 5, 6, 7} ... [BEEP]
The VRC2000 is reporting, in order of priority, the access codes for all three
security levels. The pause between the end of an access code and the [BEEP]
is four seconds long. New access codes should be entered during that four-
second pause.
To change the access codes, enter
☎ “0 9 0”
The VRC2000 will respond as before. Immediately after, the VRC2000 says
• OPERATOR ACCESS CODE IS 0, 1, 2, 3, 4
Promptly enter the following sequence of numbers:
☎ “1 1 1 1 1”
After the last number in the above sequence in entered, the VRC2000 will
respond with a double [BEEP]. The double [BEEP] indicates that a new
operator access code has been entered.
ACCESS CODE NOTE:
When entering individual access codes (operator, user or system), any five digits
can be used.
The VRC2000 will say
• USER ACCESS CODE IS 1, 2, 3, 4, 5
As soon as the VRC2000 completes this statement, enter the following
sequence of numbers:
☎ “2 2 2 2 2”
The VRC2000 will double [BEEP] again, then say
• SYSTEM ACCESS CODE IS 1, 2, 3, 4, 5, 6, 7
Promptly enter the following sequence:
☎ “3 3 3 3 3 3 3”
The VRC2000 will double [BEEP] again to confirm that a new system access
code had been entered.
To Next Page
Loading...