VRC2000 Installation and Operations Manual Page 43
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
To program metering channels, first enter the appropriate code for the
channel you would like to program. Immediately after the VRC2000 states
its message, enter the desired set-up information. All codes must be entered
before the [BEEP].
SINGLE BEEP NOTE:
The VRC2000 will emit a single [BEEP] after a set-up parameter if you do not
make a new entry. If you do make a new entry after a set-up parameter is stated
by the VRC2000, the unit will [BEEP] twice.
This process will proceed more quickly if the exact codes to be programmed
are well planned. For this purpose, this manual includes worksheets in
Appendix H: Setup Worksheets (Page 117).
Metering Channel Programming Exercise
The following exercise will illustrate more fully how to program metering
channels.
Enter
☎ “6 0 1”
The VRC2000 will respond:
• CHANNEL IDENTIFIER FOR METERING CHANNEL ONE IS ... {5 MILLISECONDS
SILENCE
, 5 MILLISECONDS SILENCE)
Enter
☎ “6 0 8 7 7 1”
The VRC2000 will respond with a double [BEEP].
The VRC2000 is now programmed to say [PLATE VOLTAGE] when
information about metering channel l is requested. Remember to enter the
DTMF sequence before the double [BEEP] signal from the VRC2000.
The VRC2000 will say
• UNITS IDENTIFIER FOR METERING CHANNEL ONE IS ... {5 MILLISECONDS SILENCE,
VOLTS}
You enter
☎ “0 4 7 7 7 2”
The VRC2000 responds with a double [BEEP].
This metering channel is now programmed to identify its units as [KILO
VOLTS], although any two words from the word list can be entered as a units
identifier.
The VRC2000 will say
• CONFIGURATION FOR METERING CHANNEL ONE IS ... {L}
To Next Page
Loading...