Gentner VRC2000 - Worksheet 10: Command Channel Setup

Page 116 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
The VRC2000 will respond with a double [BEEP].
Time-of-day function three will now trigger command channel 8 at 11:59:01
p.m. every day during the month of November.
The VRC2000 will say
• ACTIVE COMMAND CHANNEL SWITCH FOR ENTRY ONE IS ... {A ACTIVATED}
You enter
☎ “*”
The VRC2000 will respond with a double [BEEP].
Time-of-day function three will now trigger command channel 8’s A switch
at 11:59:01 p.m. every day for the month of November.
Exercise 2
Repeat the same steps listed above, only use the disable code (“0 0”) for the
time-of-day date function. Then set-up this entry to activate weekly on
Wednesday (“0 4”).
Exercise 3
Repeating the same steps listed above, but use the disable code “0” for the
day-of-the-week function. This will cause this time-of-day function to
activate daily.
Appendix G:
Continued