VRC2000 Installation and Operations Manual Page 15
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
ACCESS CODE NOTE:
If a different access code was programmed from the one in the exercise, enter the
access code programmed.
The VRC2000 should respond:
• THANK YOU. PLEASE SELECT FUNCTION FOR PROGRAMMING.
If the VRC2000 does not respond with this message, there was an error
entering the new system access code, the unit was not properly programmed
with the new system access code or the internal lithium battery was not
placed correctly.
ACCESS ERROR NOTE:
If unable to obtain access to the VRC2000’s programming functions with the new
system access code, remove AC power from the VRC2000, remove all status and
metering channel inputs from the unit, then remove the Berg jumpers on the
internal lithium battery. Replace the battery jumper, reconnect all status and
metering channel inputs, and return AC power to the VRC2000.
If not done so previously, program your own set of access codes for all three
security levels. Write these access codes into the provided spreadsheet
(Appendix H: Setup Worksheets, Page 117).
ACCESS CODE NOTE:
When determining access codes, use the letters on the DTMF pad to spell out
meaningful words. This will make the codes easier to remember.
Do not forget or lose your written record of the access codes. Do not
program the access codes carelessly. If the access codes are lost or forgotten,
the only way to gain access to the VRC2000 is to remove the jumper on the
internal lithium battery and unplug the VRC2000. This will erase all
programmed functions and all parameters and functions will have to be
reprogrammed.
Turning the VRC2000 Voice On/Off
Disabling the VRC2000’s voice functions in setup mode will allow long
strings of numbers with the DTMF pad without waiting for the voice to
respond. Doing so will speed up programming. To disable the VRC2000’s
voice functions, follow these step-by-step instructions:
Step 1
Enter setup mode (either local or remote).
Step 2
Enter
☎ “9 3 0”
The VRC2000 will respond:
• VOICE OFF.
To reactivate the voice function, enter
☎ “9 4 0”
To Next Page
Loading...