Page 18 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
SYSTEM IDENTIFIER NOTE:
For maximum security, programming the system identifier solely with silences
may be desirable.
The use of silences in the system identifier will help make the VRC2000’s
statements more understandable.
Sixty DTMF tones, entered correctly, are required to program the
VRC2000’s system identifier. Once the first DTMF tone in the
programming sequence is entered, the VRC2000 will wait until all 60 tones
are entered.
If not completed previously, now program the VRC2000 with your own
system identifier. First, decide what the unit will say (Appendix I: Word
List, Page 125). Make notes on the tones to be programmed into the
VRC2000. Remember to include exactly 20 words (60 DTMF tones) in the
system identifier.
VOICE OFF NOTE:
Using the VOICE OFF command “9 3 0” when programming the system
identifier will save time. Although it is not mandatory, always remember to turn
the voice function back on with the VOICE ON command “9 4 0” when finished.
Setting the Clock
The VRC2000 has a real-time clock and calendar used to tag alarms. Setting
this clock accurately is important. The VRC2000’s clock can also be set up
to automatically change to and from daylight savings time.
To set the VRC2000 clock, enter setup mode with the system access code.
Next, enter
☎ “0 6 0”
The VRC2000 will respond:
• TIME OF DAY HOURS ARE ... {TWELVE} ... [BEEP]
• TIME OF DAY MINUTES ARE ... {ZERO} ... [BEEP]
• TIME OF DAY SECONDS ARE ... {ZERO} ... [BEEP]
• TIME OF DAY IS ... {AM} ... [BEEP]
• DAYLIGHT SAVINGS TIME IS ... {DISABLED} ... [BEEP]
• DAY OF WEEK IS ... {WEDNESDAY} ... [BEEP]
• DATE IS ... {DECEMBER SIXTEEN, NINETEEN EIGHTY-EIGHT} ... [BEEP]
In the pauses before each [BEEP], enter new numbers that will reset each
portion of the clock/calendar.
TIME/CLOCK NOTE:
The time actually spoken by the VRC2000 may vary from the information stated
above, depending on the length of time which has elapsed since power was
applied to the unit. However, the format will be the same as indicated above.
The clock is not updated until the last number is entered for each individual
time/date function. This means the time can be set to accurate time bases
(i.e. studio clock or WWV).
VRC2000 Setup
Continued
To Next Page
Loading...