Page 60 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
To program a mute function, first enter the appropriate code for the entry to
be programmed, followed by a “#” symbol. Immediately after the VRC2000
responds, enter the set-up information to be programmed. Enter the
information before the VRC2000 emits a single [BEEP].
SINGLE BEEP NOTE:
The VRC2000 will emit a single [BEEP] after a set-up parameter if you do not
make a new entry. If you do make a new entry after a set-up parameter is stated
by the VRC2000, the unit will [BEEP] twice.
This process will proceed more quickly if the exact codes to be programmed
into each mute-function entry are well planned. Worksheets supplied in
Appendix H (See Page 117.) will aid in the planning process.
Mute Function Programming Exercise
The following mute-function programming exercise will illustrate more fully
how to program mute functions.
Enter
☎ “4 0 1 #”
MUTE FUNCTION PROGRAMMING NOTE:
The “#” symbol must be entered after the proper access code when setting up
mute functions. Entering a “*” symbol will disable the selected mute function.
The VRC2000 will respond:
• STATUS CHANNEL NUMBER FOR DISARM ONE IS ... {ONE}
VRC2000 Setup
Continued
Table 11. Mute Function Access Codes
To Access
You Enter Mute Function
☎ “4 0 1” 1
☎ “4 0 2” 2
☎ “4 0 3” 3
☎ “4 0 4” 4
☎ “4 0 5” 5
☎ “4 0 6” 6
☎ “4 0 7” 7
☎ “4 0 8” 8
☎ “4 0 9” 9
☎ “4 1 0” 10
(continuing through)
☎ “4 3 8” 38
☎ “4 3 9” 39
☎ “4 4 0” 40
To Next Page
Loading...