Gentner VRC2000 - Entering Time;Date on Time-Of-Day Functions; Table 10. Time-Of-Day Function Access Codes

VRC2000 Installation and Operations Manual Page 55
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
You enter
☎ “3 0 1 *”
The VRC2000 will respond:
• TIME-OF-DAY HOURS FOR ENTRY ONE ARE ... {DISABLED}
DEFAULT SETTING NOTE:
As shipped from the factory, all time-of-day functions are disabled.
Enter a “#” symbol after the code to enable that time-of-day function.
Entering “#” will also allow programming of the selected time-of-day
function. Entering a “*” symbol will disable the selected time-of-day
function.
There are 64 time-of-day function entries available on your VRC2000. The
metering channels are accessed with the codes listed in Table 10 (below).
To program a time-of-day function, first enter the appropriate access code,
then enter a “#”. Immediately after the VRC2000 responds, enter desired set-
up information. Enter your information before the VRC2000 emits a single
[BEEP].
This process run more quickly and easily if exact codes to be programmed
into each time-of-day entry are well planned. Worksheets supplied in
Appendix H (See Page 117.) will help in the planning process.
Entering Time/Date On Time-Of-Day Functions
The time in which a time-of-day function activates must include two digits,
be it the month, hour, minute or second.
Example
Entering “0 3” would mean the third month (March), third day,third hour,
Table 10. Time-Of-Day Function Access Codes
To Access
You Enter Time-Of-Day Function
☎ “3 0 1” 1
☎ “3 0 2” 2
☎ “3 0 3” 3
☎ “3 0 4” 4
☎ “3 0 5” 5
☎ “3 0 6” 6
☎ “3 0 7” 7
☎ “3 0 8” 8
☎ “3 0 9” 9
☎ “3 1 0” 10
(continuing through)
☎ “3 6 2” 62
☎ “3 6 3” 63
☎ “3 6 4” 64