Page 82 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
DATA INTERFACE DEACTIVATION NOTE:
It is not always possible to turn the Data Interface OFF with the “0 2 0 *” code.
The noise created by the Data Interface will sometimes prevent the unit from
properly decoding the command. However, the Data Interface will automatically
turn itself OFF after 45 seconds if it has not established a modem connection.
Refer to the Data Interface Installation and Operations Manual, Setup
VRC2000 Installation and Operations Manual, and/or VRC-Win Installation
and Operations Manual for information on how to install and use the Data
Interface.
Auto-Logging
If your VRC2000 is equipped with the Data Interface, the system can be
configured to automatically dial an outbound telephone number (or key on a
two-way radio system’s PTT switch), turn on the Data Interface, and
transmit all metering and status-channel readings to a PC running Setup
VRC2000 software in terminal mode or VRC-Win software. The system can
be programmed to auto-log at regular intervals. These intervals can be as
short as 15 minutes, or as long as 11 hours and 59 minutes.
Refer to the Data Interface Installation and Operations Manual, Setup
VRC2000 Installation and Operations Manual, and/or VRC-Win Installation
and Operations Manual for more information about auto-logging.
Auto-logging can only be enabled/disabled in the set-up mode.
DATA INTERFACE NOTE:
A Data Interface must be installed in the VRC2000 to use auto-logging.
Operation
Continued
To Next Page
Loading...