Page 114 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
This indicates that you have successfully signed off from VRC2000 remote
user mode.
The following exercises will familiarize you with programming time-of-day
functions.
Exercise 1
In the following exercise, program time-of-day function three to activate the
A switch for command channel 8 every day for the month of November at
11:59:01 p.m.
TIME-OF-DAY PROGRAMMING NOTE:
Enter the #” symbol after the proper access code to program time-of-day
functions. Entering the “*” symbol will disable that time-of-day function.
The VRC2000 will report only a single [BEEP] after a set-up parameter if
you do not make a new entry. If you do make a new entry, the VRC2000 will
[BEEP] twice.
Enter
☎ “3 0 3 #”
The VRC2000 will respond:
• TIME-OF-DAY HOURS FOR ENTRY THREE ARE ... {TEN}
You enter
☎ “1 1”
The VRC2000 will respond with a double [BEEP].
Time-of-day function entry three will now activate at the eleventh hour.
The VRC2000 will say
• TIME-OF-DAY MINUTES FOR ENTRY THREE ARE ... {TEN}
You enter
☎ “5 9”
The VRC2000 will respond with a double [BEEP].
Time-of-day function entry three will now activate at the fifty-ninth minute
of the selected hour.
The VRC2000 will say
• TIME-OF-DAY SECONDS FOR ENTRY THREE ARE ... {TEN}
You enter
☎ “0 1"
Appendix F:
Continued
Appendix G: Time-Of-Day
Function Tutorial
To Next Page
Loading...