VRC2000 Installation and Operations Manual Page 91
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
The VRC2000 is a microprocessor-based system. All firmware for the unit was developed by Gentner Communications
Corporation. Your new VRC2000 was shipped in a sealed static-protective bag with a label referring you to the
conditions outlined in the firmware license agreement (below). When this seal is broken, the terms and conditions of
this agreement become effective.
Gentner Firmware License Agreement
Gentner Communications Corporation (hereinafter referred to as Gentner) is the sole owner of the VRC2000 firmware.
The VRC2000 firmware is defined as all software stored in the memory device supplied with this license. Gentner
grants to the purchaser and/or the end-user of the VRC2000 Voice Remote Control a nonexclusive license to use the
firmware under the following terms and conditions:
THIS FIRMWARE IS
A. For use on only the VRC2000 which has been purchased and properly registered by serial number with Gentner.
B. Not to be copied or duplicated in any way, and not to be transferred or delivered to any other person or entity without
the written consent of Gentner.
C. Protected by all applicable copyright and patent laws. The copyrights and patents assigned to Gentner for the
VRC2000 remain the sole property of Gentner.
This license does not assign or transfer ownership of the firmware. Included in this license is all information contained
in the instructional manuals, schematic diagrams and related materials.
This license shall remain in effect for the life of your VRC2000. You may terminate the license by returning the
VRC2000 to Gentner in its original container, seal intact. This license is automatically terminated if you violate any of
the terms and conditions of this license. Upon such termination, the VRC2000 must be returned to Gentner.
Cancellation or termination of this license agreement shall not result in the return or refund of funds if the seal on the
original container has been broken or is not fully intact.
This license agreement is granted solely to the original purchaser of the VRC2000. If the VRC2000, and thus the
firmware and this license, is to be passed to another person or entity in any way, the original purchaser must advise
Gentner in writing of this transfer. The new holder of the VRC2000 must acknowledge in writing acceptance of the
terms and conditions of this license. The license shall be deemed terminated if such written acceptance is not presented
to Gentner.
Firmware
License
To Next Page
Loading...