VRC2000 Installation and Operations Manual Page 75
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
• ALARMS PENDING
If there are no alarms, it will say
• NO ALARMS PENDING
Step 3 — Request Status Reading
Enter the following code in order to request a reading from a status channel:
☎ “7 x x *”
x x NOTE:
Substitute the appropriate code for the x x that corresponds with the channel
number to be accessed (i.e. 01 is channel 1, 11 is channel 11).
The VRC2000 will respond with the phrase set up for the status channel,
followed by the phrase set up for the actual current state of the status
channel.
Step 4 — Request Meter Reading
Enter the following code in order to request information about a metering
channel:
☎ “6 x x *”
The VRC2000 will respond with the phrase set up for the metering channel,
followed by the phrase set up for the actual current reading of the metering
channel.
Step 5 — Sign Off
Sign off from the VRC2000 by entering the following code:
☎ “9 9 9”
The VRC2000 will respond:
• GOOD-BYE
Then the unit will automatically hang up the telephone line.
HANG-UP NOTE:
The VRC2000 will also automatically hang up if no codes are entered for a
period of five minutes (if the inactivity timer is enabled).
Single/Multiple Responses From Status/Metering Channels
Either single or multiple responses can be requested from status and
metering channels.
Single Response
A single response is requested by entering “*” after the status or metering-
channel code. This instructs the VRC2000 to send only a single response to
your request, which will be accurate as of the exact time the “*” was
entered.
Multiple Response
A multiple response is requested by entering “#” after the status or metering-
To Next Page
Loading...