Gentner VRC2000 - Table 1. System Identifier Word List

VRC2000 Installation and Operations Manual Page 17
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
This statement can be altered to include the station call letters or other words
relevant to the facility.
To change the system identifier, first sign on to the VRC2000 in the setup
mode and enter the system access code. Then enter
☎ “0 8 0”
The VRC2000 will respond with the same message stated on the previous
page.
Now enter the following sequence of DTMF tones (Table 1, below):
The VRC2000’s system identifier is now programmed. Verify that the new
system identifier was correctly programmed by entering the “0 8 0” sequence
on the DTMF pad.
The VRC2000 can be programmed with almost any desired statement; the
only limit is the VRC2000’s vocabulary of almost 800 words. Refer to the
Appendix I: Word List (See Page 125.) for a complete listing of the
VRC2000’s vocabulary.
Gentner Communications recommends that the system identifier always
begin with the words
• HELLO. THIS IS THE ....
Also always use the words
• PLEASE ENTER ACCESS CODE
at the end of the system identifier. This will remind users that they have to
enter an access code to operate a VRC2000.
Table 1. System Identifier Word List
DTMF Code Word Definition
☎ “4 6 4” • HELLO
☎ “7 2 6” • THIS
☎ “4 9 7” • IS
☎ “7 2 2” • THE
☎ “1 0 0” • A
☎ “1 0 1” • B
☎ “1 0 2” • C
☎ “1 0 3” • D
☎ “7 3 9” • TRANSMITTER
☎ “6 8 5” • SITE
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “0 5 6” • (5 MILLISECONDS SILENCE)
☎ “6 1 0” • PLEASE
☎ “4 0 0” • ENTER
☎ “2 0 4” • ACCESS
☎ “3 1 0” • CODE