Page 34 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
IS ...{A}
Now enter a code that will tell the VRC2000 which switch on command
channel 3 to automatically activate when status channel 1 goes low.
You enter
☎ “#”
The VRC2000 will respond with the double [BEEP].
The VRC2000 is now programmed to automatically fire command channel
3’s B switch when status channel 1 goes low.
Enter “#” to program switch B for the selected command channel; enter “*”
to program switch A of the selected command channel.
The VRC2000 will say
• HIGH INPUT IDENTIFIER FOR STATUS CHANNEL ONE IS ... {INPUT OPEN}
You enter
☎ “5 1 3 5 7 5”
The VRC2000 will respond with a double [BEEP].
The unit will now answer [LIGHTS ON] when information about status
channel 1 is requested, and it is in the open state.
The VRC2000 will say
• ALARM ON HIGH INPUT OF STATUS CHANNEL ONE IS ... {DISABLED}
You enter
☎ “*”
The VRC2000 will respond with a double [BEEP].
The alarm for status channel 1’s high input is now disabled. The VRC2000
will not activate an alarm condition when the state of status channel 1
switches open.
When programming the VRC2000, enter a “#” symbol to enable the alarm
for this parameter. Enter “*” to disable the alarm.
The VRC2000 will say
• COMMAND CHANNEL NUMBER FOR HIGH INPUT OF STATUS CHANNEL ONE IS ...
{DISABLED}
You enter
☎ “0 4”
VRC2000 Setup
Continued
To Next Page
Loading...