VRC2000 Installation and Operations Manual Page 53
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
You enter
☎ “6 0 8 7 7 1”
The VRC2000 will respond with a double [BEEP].
The VRC2000 will now say [PLATE VOLTAGE] when a command is issued
to command channel l.
The VRC2000 will say
• CONFIGURATION FOR COMMAND CHANNEL ONE IS ... {M}
You enter
☎ “*”
The VRC2000 will respond with a double [BEEP].
The switches for command channel 1 are now set to be momentary. Use “*”
to program command-channel switches as momentary, “#” latching.
The VRC2000 will say
• SWITCH A IDENTIFIER FOR COMMAND CHANNEL ONE IS ... {A ACTIVATED}
You enter
☎ “6 3 4 7 7 1”
The VRC2000 will respond with a double [BEEP].
The VRC2000 will now say [RAISE VOLTAGE] when switch A for
command channel 1 is energized.
The VRC2000 will say
• SWITCH B IDENTIFIER FOR COMMAND CHANNEL ONE IS ... {B ACTIVATED}
You enter
☎ “5 2 9 7 7 1”
The VRC2000 will respond with a double [BEEP].
The VRC2000 will now say [LOWER VOLTAGE] when switch B for
command channel 1 is activated.
The VRC2000 will say
• ACTIVE DELAY FOR COMMAND CHANNEL ONE IS ... {FOUR}
You enter
☎ “0 0 8”
To Next Page
Loading...