GM V2H Bundle - GETTING TO KNOW YOUR SYSTEM; Each Component Has a Job

GM Energy V2H Bundle Installation Manual 5
SAFETY, WARNINGS, AND COMPLIANCE
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS – This manual contains important instructions for the GM Energy V2H Bundle
(GM Energy PowerShift e1.19, GM Energy Inverter e1.11, GM Energy Home Hub e1.200, GM Energy Dark Start
Delta9.6V25Ah) that should be followed during installation and maintenance
DANGER! Indicates a hazard with a high level of risk which will result in serious injury or death
WARNING! Indicates a hazard that could result in injury or death.
CAUTION! Indicates a hazard that could result in property or equipment damage.
PROTECTIVE EARTH GROUND: Identifies terminals which are intended for connection to an
external conductor for protection against electrical shock in case of a fault
WARNING! To ensure that the V2H Bundle (“the system”) will operate and perform safely and as
intended, the system must be designed, installed, commissioned, and placed into operation only by
qualified persons, and in compliance with all product requirements, including, but not limited to:
equipment integrated as Listed and not exceeding capacities or ratings; equipment secured,
fastened, and sealed as required; equipment components installed per National Electric Code
ANSI/NFPA 70 requirements and best practices; equipment commissioned, provisioned, and tested
as required; and end users oriented for proper operation.
DANGER! The installation, adjustment, commissioning, or repair of the system involves the risk of
contact with potentially lethal voltages and currents. Read this entire guide before beginning the
installation. Note and observe all warnings and remove all sources of energy prior to interfacing
wiring or electrical panels.
WARNING! The GM Energy Home V2H Bundle should not be used as a primary or backup power
source for medical equipment or any other products in which failure could lead to injury or loss of
life.
CAUTION! If the equipment is damaged during installation, stop the installation, and contact the
GM Energy Support Center at 1-833-64POWER