GW Instek GDM-8261 - Configure RS-232 C Interface

REMOTE CONTROL
127
Configure RS-232C Interface
Configuration
step
1. Press the Shift key, the 2nd
(Menu) key, the left key
repeatedly until the I/O
configuration menu appears.
2ND
MENU
2. Press the Down key. The
RS-232C selection display
appears.
3. Press Enter or Down to confirm
RS232 selection.
or
4. Press the Down or UP keys
repeatedly to select the baud rate.
2304001152005760038400192009600
5. Press the Enter key followed by
the Exit key. The RS-232 setting
is stored and the display goes
back to the default display.
6. Connect the RS-232C cable to
the rear panel terminal.
RS-232C pin
assignment
Pin 2: RxD
Pin 3: TxD
Pin 5: GND
Pin 1, 4, 6 ~ 9: No Connection
5 4 3 2 1
9 8 7 6
PC – GDM
RS-232C
Connection
A
n
ull-modem connection, in which transmit (TxD) and
receive (RxD) lines are cross-linked, is required.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com