HALE SmartFOAM - Apparatus Information; Revision Record

Page 1
SmartFOAM
APPARATUS INFORMATION
Hale SmartFOAM System Serial Num-
ber
In Service Date
Fire Department
Engine Number
Calibration Factors:
Water Flow – high calibration point
Water flow Pulses
Water Flow – low calibration point
Water flow
Pulses
Class A Foam Factor
NOTICE!
Hale Products does not assume responsibility for product failure resulting from improper maintenance or operation.
Hale Products is responsible only to the limits stated in the product warranty. Product specifications contained in this
manual are subject to change without notice.
All Hale products are quality components -- ruggedly designed, accurately machined, precision inspected, carefully as-
sembled and thoroughly tested. In order to maintain the high quality of your unit, and to keep it in a ready condition, it is
important to follow the instructions on care and operation. Proper use and good preventive maintenance will lengthen
the life of your unit.
REVISION RECORD
Revi-
sion
Date
Page
Description
A
DEC 2015
All
New Issue
B
FEB 2018
6
12, 13
22, 34, 35, 47
23, 53, 54
36
82
83-84
87, 90
State all foam models not just 1.7/2.1
Add new Motor Driver drawings
Add pictures of piston and gear pump w/ new motor driver
Add new harness part numbers and information
Add new mounting information
Updated closed loop control diagram and system overview
Add new motor driver information
Add new Assembly drawings
C
JUN 2020
10
12-14
23
34-35
56-57
93
Adjusted tables to include converter on 6.5-12V system
Updated Figure 2 and added Figures 3, 4, & 5
Added system picture for 6.5-12V
Adjusted Table 6 and added Figure 14 for 6.5-12V system
Added Figures 43 & 44
Added 6.5-12V system specific part numbers
D
JUL 2020
9
23-28
39
86
90
97
Updated maximum flow solution table
Added Dual Pump System diagrams
Added relevant Dual Pump information
Added Dual Pump system descriptions
Change water flow calibration to annually
Added Check Valve