Page 6
SAFETY
IMPORTANT!
ALL HALE SMARTFOAM MODELS ELECTRONIC
FOAM
PROPORTIONING SYSTEMS ARE DE-
SIGNED FOR OPTIMUM SAFETY OF ITS OPERA-
TORS
AND TO PROVIDE RELIABLE AND SAFE
FOAM
CONCENTRATE INJECTION. FOR ADDED
PROTECTION AND BEFORE ATTEMPTING INSTAL-
LATION OR OPERATION PLEASE FOLLOW
THE
SAFETY GUIDELINES LISTED IN THIS SECTION
AND ADHERE TO ALL WARNING, DANGER, CAU-
TION AND IMPORTANT NOTES FOUND WITHIN
THIS
GUIDE.
THIS SECTION ON SAFETY MUST BE CAREFULLY
READ, UNDERSTOOD AND ADHERED TO
STRICTLY
BY ALL INSTALLERS AND OPERATORS
BEFORE
ATTEMPTING TO INSTALL OR OPERATE
THE SMARTFOAM PROPORTIONING SYSTEM.
INCORPORATE THE WARNINGS AND CAUTIONS
AS WRITTEN WHEN DEVELOPING DEPART-
MENTAL APPARATUS OPERATING PROCEDURES.
SmartFOAM is a trademark of Hale Products, In-
corporated. All other brand and product names are
the trademarks of their respective holders.
GUIDELINES
READ ALL INSTRUCTIONS THOROUGHLY BEFORE
BEGINNING ANY INSTALLATION OR OPERATION
PROCESS.
❑
Installation should be performed by a trained and
qualified installer, or your authorized Hale Prod-
ucts service representative.
❑ Be sure the installer has sufficient knowledge, ex-
perience and the proper tools before attempting
any installation.
❑ Make sure proper personal protective equipment is
used when operating or servicing apparatus.
❑ A foam tank low level sensor must be utilized to
protect the Hale Foam proportioner from dry run-
ning. Failure to use a low level sensor with the
Hale Foam system voids warranty.
❑ DO NOT permanently remove or alter any
guard or insulating devices, or attempt to
op-
erate the system when these guards are re-
moved.
❑ Make sure all access/service panels and covers
are installed, closed and latched tight,
where ap-
plicable.
❑ DO NOT remove or alter any hydraulic or pneu-
matic connections, electrical devices, etc. DO
NOT tamper with or disconnect safety
features or
modify protective guards (such as covers or
doors). DO NOT add or remove structural parts.
Doing so voids the warranty.
Any of the above could affect system capacity and/or
safe operation of the system and is a serious safety
violation which could cause personal injury, could
weaken the construction of the system or could affect
safe operation of
the SmartFOAM Proportioning Sys-
tem.
WARNING!
NO MODIFICATIONS OR ADDITIONS MAY BE
MADE TO THE SMARTFOAM PORPORTIONING
SYSTEM
WITHOUT PRIOR WRITTEN PERMISSION
FROM:
HALE PRODUCTS, INC
607 NW 27
th
Avenue
Ocala, Florida 34475 USA
Telephone: 352-629-5020
FAX: 800-533-3569
❑ All electrical systems have the potential to
cause sparks during service. Take care to
elimi-
nate explosive or hazardous environments dur-
ing service and/or repair.
❑ To prevent electrical shock always disconnect the
primary power source before attempting to service
any part of the Hale Foam system.
❑ To prevent system damage or electrical shock
the main power supply wire is the last connec-
tion made to the Hale Foam motor controller.
❑ Release all pressure then drain all concentrate and
water from the system before servicing any of its
component parts.
To Next Page
Loading...
