Hasler WJ185 - Page 143

Trouble shooting 143
ORIG0140-143
4127718F/B
02/26/2007
PROBLEM
Poor printing quality
Envelopes are stained
Poor moistening or no
moistening (standard
automatic feeder)
Poor moistening or no
moistening (mixed-mail
feeder).
SOLUTION
- See paragraph "Cleaning the
printhead".
- Make sure that the side drawer is
properly closed.
- Make sure that the side drawer is
properly closed.
- Clean rollers (see “General
maintenance” section ) and the
table.
- Is the machine in the moistening
mode?
- Make sure that the bottle is not
overfilled or empty.
- Slightly shake the bottle to
eliminate air bubbles.
- Check the brush and the sponges
(see “General maintenance”
section ).
Is the moistening mode selected
appropriate?
- Make sure that the bottle is not
overfilled (see section A, "Filling
of the water bottle").
- Gently shake the water bottle in
order to eliminate air bubbles.
- 1: increase the moistening level
- 2: if step 1 is not effective, clean
the filter (see "General
Maintenance" in section C).
- 3: if step 2 is not effective, clean
the moistening ramp.