Hasler WJ185 - With the Feed Platform Alone; Labels

Entering Postage Value and Mail Processing 73
ORIG0140-73
4127718F/B
02/26/2007
- Press
START
STOP
: the whole envelope series is printed at the
defined value.
To stop the batch, press key
START
STOP
again (or wait for a few
seconds until the machine stops automatically when there are no
more envelopes to be processed).
4.2.3 With the feed platform alone
Press key
START
STOP
to start the mailing machine. Place one
envelope at a time on the platform, with its upper edge resting
against the side guide and push the envelope towards the mailing
machine, until it is fed into the machine.
To stop the envelope feeding, press key
START
STO P
again.
4.2.4 Labels
- Press key ;
- If required, enter the number of labels to be processed (from 1
to 999) at the same value (default value is 1).
- Press on key
START
STOP
: The machine will automatically provide the
required number of labels at the displayed value.
For a single label, simply press and then
START
STOP
.
When an RTD is connected to the mailing machine,
please refer to paragraph "Operation with a roll tape
dispenser (RTD)".