37
GB
• If the ash is used when the shutter button is pressed, a custom white balance is registered with
the ash light taken into account. Take pictures with the ash in later shootings.
• e message “Custom WB error” indicates that the value is beyond the expected range. (When
the ash is used on a subject in close proximity or a subject with a bright color is in the frame.) If you
register this value, the indicator turns yellow on the recording information display. You can shoot
at this point, but it is recommended that you set the white balance again to get a more accurate white
balance value.
1 Select [Custom] with the control dial L.
2 Select (Custom Setup)] with soft key B.
3 Hold the camera so that the white area fully covers the AF area located in
the center, and then press the shutter button down.
e shutter clicks and the calibrated values (color temperature and color lter) are
displayed.
• If you nely adjust the color between blue (B) and amber (A), and between green (G) and magenta
(M) for a certain color temperature in [C.Temp./Filter], the adjusted value is retained even if you
select another color temperature.
Custom white balance
Table of
contents
Table of
contents
Sample photo
Menu Index
Notes
To Next Page
Loading...
