HBK FUSION - HEALTH AND SAFETY INFORMATION; Before use; End of use; Warnings

Health and safety information
HEALTH AND SAFETY INFORMATION
This document contains information and warnings which must be followed to ensure safe operation and to
maintain the product in safe condition.
This product has been designed and tested in accordance with:
l
EN/IEC61010-1 and ANSI/UL61010-1: Safety requirements for electrical equipment for
measurement, control and laboratory use
l
EN55011:2016: Industrial, scientific and medical equipment – Radio-frequency (RF) disturbance
characteristics. Limits and methods of measurement
Group1: Devices that intentionally generate no more than 9kHz of RF energy
If the product is not used as intended, the protection provided by the product may be impaired.
Before use
When it is unpacked, check the product for visible signs of damage. If damage has occurred, the product
must not be operated.
If the product is damaged, operated without being acclimatized, or incorrectly stored or transported, the
protection provided by the product may be impaired.
End of use
HBK complies with the EU’s Waste Electrical and Electronic Equipment (WEEE) Directive, which
issues the following waste handling instructions:
l
Waste electrical and electronic equipment or batteries may be returned to your local
HBK office for disposal.
l
Do not dispose of electronic equipment or batteries as unsorted municipal waste.
Warnings
If the product is used outside the rated operating conditions or is not used as intended, the protection
provided by the product may be impaired.
According to EN55011, this is a Class A product, suitable for use in all areas, apart from the domestic
environment, where devices are directly connected to a low-voltage power supply network. This product
may cause radio interference in a domestic environment, and therefore you should take extra measures to
avoid this.
- 11 -