HBK FUSION - Proper use; Connection; Working safely

Proper use
Electrical hazards
Voltages with no energy limit that exceed one of the following values are rated as dangerous according to
EN61010:
l
AC voltage, 30Vrms value
l
AC voltage, 42.4Vpeak value
l
DC voltage, 60V
When applying dangerous contact voltages, you must comply with all related safety requirements.
Risk due to poor insulation of external circuits: only devices that comply with the requirements of IEC61010-
1, IEC61010-2-030 and IEC60950 may be connected.
To avoid injury from coming into contact with dangerously active electric potential: do not wear jewellery
(rings, watches, etc.) and do not touch any live parts. Comply with safety rules: isolate, secure, check, ground
and short-circuit, cover and safeguard.
Proper use
Connection
For devices connected to a network, safety precautions must be taken to ensure that line breaks and other
signal transmission interruptions do not occur in order to minimise data loss and other undefined states.
Only approved accessories can be used or connected to the product.
To disconnect the product and its power supply from the AC supply completely, unplug the mains power
cable.
Working safely
When it is unpacked, check the product for visible signs of damage. If damage has occurred, the product
must not be operated.
Proper and safe operation requires proper transportation, correct storage, siting and mounting and careful
operation. Follow all instructions in this manual to ensure the proper and safe operation of your product.
In the following situations, the product must be shut down and secured to prevent inadvertent operation:
l
Visible signs of damage to the product
l
(Audibly) loose parts in the product
l
The product no longer works
The covers protect the user from live parts and should only be removed by suitably qualified personnel for
maintenance and repair purposes. The product must not be operated with the covers removed.
At the rear of the product, there is a cover with non-functional slots. Do not remove during operation. Do
not attempt to use the slots.
- 13 -