Replacing air filters
Personnel who are not sufficiently qualified are particularly exposed to the risk related to electric shock, arc
flash burn, arc blast explosion and other phenomena.
Replacing air filters
The product is designed for use in clean and dry rooms with pollution degree 2. It is recommended to
replace the air filter annually.
The air filter is located on the underside of the frame. Before you replace an air filter:
l
Switch the power off and disconnect all cables (Ethernet, power and sensor cables).
l
Remove the boards from the frame to reduce its weight (optional).
On the underside of the frame:
1. Unfold the two foot extensions.
2. Use a six-point star screwdriver to remove the 10 screws that hold the ventilation plate in place.
3. Remove the plate to access the air filter.
4. Remove the air filter.
5. Insert a new air filter in the frame.
6. Replace the ventilation plate and the screws which hold the plate in place.
Cleaning
HBK FUSION is a maintenance-free product. However, you can clean the housing with a soft, slightly damp
(not wet!) cloth.
Please note the following information before cleaning the housing:
l
Disconnect the hardware completely from all current and voltage supplies.
l
Never use solvents as these could damage the housing or important labelling.
l
Ensure that no liquid gets into the housing or connections.
l
Give the hardware sufficient time to dry before starting it up again.
If the hardware is not properly cleaned, the protection provided by the hardware may be impaired.
Transportation, storage and disposal
Transport
When unpacking the contents of the package, check that everything is present. When it is unpacked, the
hardware should be inspected for mechanical damage. If damage has occurred during transit, the hardware
- 68 -
To Next Page
Loading...
