HBK FUSION - Edit synchronization settings; Edit fan settings

Edit synchronization settings
6. Enter the Gateway address, for example 172.17.123.200.
7. Click Apply.
Edit synchronization settings
It is possible to configure the synchronization between frames.
1. In a web browser, enter the frame's IP address in the address bar.
2. Go to the Settings tab.
3. Under Time Synchronization Settings, define the following parameters:
l
PTP clock type: Select between:
o
Ordinary Boundary: (default) Hybrid between master and slave
o
Slave Only
o
Master Only
l
PTP domain: Enter the PTP domain number
l
Delay mechanism: Select between:
o
PTP: (default) peer to peer
o
E2E: end to end, allows PTP synchronization to work using transparent clocks or non-
PTP-aware networks
4. Click Apply.
Edit fan settings
To change the fan settings for the frame, you must go to the frame's web page.
1. In a web browser, enter the frame's IP address in the address bar.
2. Go to the Settings tab.
3. Select a mode of operation. The modes are named based on their intended use:
l
Silent
l
Office
l
Factory
l
Maximum
4. Click Apply.
- 65 -