102
6. Press the Menu button.
✓ The standard display of i-01 is shown again.
6.5 Selecting and changing parameters
On the HDG Compatronic control unit, various parameters can be se-
lected and altered.
✎ See section “6.10 Structure of the menus” in this chapter.
SELECTING A LEVEL
Select the required level as follows:
C
USTOMER LEVEL 1. Press the Enter button.
✓ The customer level is shown on the display.
or
S
ERVICE LEVEL 1. Simultaneously press the Plus and Enter buttons.
✓ The service level is shown on the display.
✓ You are in a submenu.
P
ARAMETER
S
ELECTING
2. Use the Up or Down button to select the desired parameter group.
3. Press the Enter button.
4. Select the parameter to be changed.
5. Press the Up or Down button.
✓ The display will change to show the previous or the next para-
meter.
6. Repeat the procedure until the parameter to be changed appears
on the display.
✓ The parameter to be changed is shown on the display.
C
HANGING PARAMETERS 7. Press the Enter button.
✓ The cursor flashes beneath the parameter to be changed.
✓ The displayed value can now be changed.
8. Press the Plus or Minus button.
✓ The value of the parameter is increased or decreased.
9. Press the Up or Down button.
✓ The cursor will jump to the next digit.
10.The Plus or Minus buttons can be used to change the value.
11.Press the Enter button.
✓ The changed value is confirmed.
✓ The selected parameter has been changed.
To Next Page
Loading...
