115
CUSTOMER AND SERVICE LEVELS
1. Press the Enter button.
✓ The customer level is shown on the display.
or
1. Simultaneously press the Plus and Enter buttons.
✓ The service level is shown on the display.
✓ The cursor is positioned next to the parameter level 1-General.
2. To call up the selection of the 1-General parameters, press the
Enter button.
3. Use the Up or Down buttons to select the individual parameters.
4. Repeat steps 2 and 3 for each parameter group or parameter.
i-33 Buffer house 2
Temp. top 77?
Temp. bottom 65°C
Pump off
• District heating pump 2
Current temperature at top of accumulator
Current temperature at bottom of accumulator
Status of district heating pump
Date and time
Tu; 09.09.2008
14:49:37
• Date and time
Weekday; date
Time
i-35 Remote maintenance
Status Modem init
• Remote maintenance
HDG Bavaria
Wood chip boiler
TRI Fuel 1
2010-06-23 GB,NL,FR
• Software version
No. Display Description
Table 6/2 - Information level
Danger!
Material damage and injury due to incorrect settings!
Setting these parameters requires comprehensive specialist know-
ledge. If the parameters are set by an untrained person, the heating
system can be damaged.
Only allow qualified specialists to change parameters.
All available system parameters are listed below.
In the service or customer level, not all of the following displayed
parameters will appear.
To Next Page
Loading...
