152
14.Switch the heating system on again.
✎ See the chapter entitled “6 Using the heating system”, section
“6.2 Switching on the heating system”.
✓ Inspection and emptying of the ash containers is completed.
LUBRICATING THE FEEDING SYSTEM
The feeding system must be lubricated every 150 operating hours.
✓ The feeding system is lubricated.
CHECKING THE DRIVE CHAINS
Important!
✎ See “Generally applicable safety instructions” in this section.
1. Place the grease gun on the
lubricating nipple (1).
2. Press three strokes of grease
into the feeding system.
Figure 7/7 - Lubricating the feeding system
Important!
✎ See “Generally applicable safety instructions” in this section.
Warning!
Risk of injury from automatically driven components
When the heating system is switched on, the gears and drive chains
that move the various augers rotate. Fingers could be crushed du-
ring cleaning and maintenance work.
Switch the heating system off before checking the drive chains.
To Next Page
Loading...
