176
F153 Safety circuit
Klixon feeding
syst.
• Motor too hot
• Cable not connected
• Motor overload
• Check current consumption
and connection
• Check connection
F154 Safety circuit
Klixon dosage
• Motor too hot
• Cable not connected
• Motor overload
• Check current consumption
and connection
• Check connection
F155 Safety circuit
Klixon delivery
syst
• Motor too hot
• Cable not connected
• Motor overload
• Check current consumption
and connection
• Check connection
F160 Error external
feeding units
• Terminals 32 + 33 not
bridged
• External conveyor fault
• Check terminals
F161 Klixon
Ash auger
• Motor too hot
• Cable not connected
• Motor overload
• Check current consumption
and connection
F162 Klixon
boiler cleaning
• Motor too hot
• Cable not connected
• Motor overload
• Check current consumption
and connection
F170 No connection to
GSM module
• No telephone card in GSM
module
• No GSM module available
• Check GSM module
• Cable not connected
• Parameter 1-10 incorrectly
set
F171 GSM error, no
signal
No network or
SIM card
• Radio network not available
• Antenna connection
• No SIM card in the modem
• Insert SIM card
• Connect antenna cable
F172 Modem not con-
nected
• Cable at interface of PC (RS
232) or telephone box not
connected
• Check cables
• Fault is only activated during
remote maintenance with
modem
F180 Transport module
(IO21) wrong
version
• Wrong transport module • Exchange transport module
• Notify HDG customer service
F181 Phase L2+L3 con-
nected
• Wrong phase setting • Notify HDG customer service
F200 CAN data trans-
fer wrong ID
• System malfunction • Notify HDG customer service
F201 CAN-BUS
error(read)
• System malfunction • Notify HDG customer service
No. Fault Cause Remedy
Table 8/1 - Faults
To Next Page
