HEIDENHAIN iTNC 530 HSCI - Page 587

31 – 588 HEIDENHAIN Service Manual iTNC 530 HSCI
MP1213 Limit frequency for advanced HSC filter
Input: 0: Filter is switched off
0.0 to 166.0 [Hz]
PLC
MP1222 Tolerance for curvature changes with HSC filter (only effective if MP7684 bit 4 = 0)
Entry:0: Do not include the tolerance
1: Include the tolerance
PLC
RUN
MP1223 Tolerance for curvature changes with advanced HSC filter
(only effective if MP7684 bit 4 = 0)
Entry:0: Do not include the tolerance
1: Include the tolerance
PLC
RUN
MP1230.x Max. permissible axis-specific jerk at corners for single filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1231.x Max. permissible axis-specific jerk at corners for double filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1232.x Max. permissible axis-specific jerk at corners for HSC filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1233.x Max. permissible axis-specific jerk at corners for advanced HSC filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1240.x Max. permissible axis-specific jerk at curvature changes for single filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1241.x Max. permissible axis-specific jerk at curvature changes for double filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1242.x Max. permissible axis-specific jerk at curvature changes for HSC filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1243.x Max. permissible axis-specific jerk at curvature changes for advanced HSC filter
Input: 0.1 to 1000.0 [m/s³]
PLC
RUN
MP1250.x Factor for axis-specific jerk at corners at rapid traverse (from value in MP123x.x)
Input: 0.0000 to 30.0000
1: No change at rapid traverse
PLC
RUN
MP1262 Filter order used for HSC filters
Input: 0 to 31 [filter order]
31: Default
PLC
RUN
MP1263 Filter order used for advanced HSC filters
Input: 0 to 31 [filter order]
31: Default
PLC
RUN
MP1290 Only with option #40: Maximum angle tolerance for DCM (Dynamic Collision Monitoring)
Input: 0.0000° to 3.0000°
3: Default
PLC
RUN
MP1292 Only with option #40: Manual oversize for DCM (Dynamic Collision Monitoring)
Input: 0 to 1000 [mm]
0: Default
PLC
RUN
MP1294 Only with option #40: Higher traversing speed for Dynamic Collision Monitoring (DCM)
through movement of only a single axis
Input: 0: Function inactive
1: Function active
PLC
RUN
MP1320 Direction for traversing the reference marks
Format: %xxxxxxxxxxxxxxxxxx
Input: Bit 0 to Bit 17 represent axis 1 to 18
0: Positive
1: Negative
PLC
RUN
MP Function and input Software
version and
behavior