Enable: Check " " to turn on / off motion detection alarm.
Set Area: Select all areas by default, click to enter the area setting
interface, set the range of the dynamic detection area, press and hold
the left mouse button to select the alarm area. After selection, the
alarm area is replaced by the red grid. Select the red grid again to cancel
the alarm area setting.
Sensitivity: According to the need, can be set 0-10 eleven file sensitivity,
the higher the value, the more sensitive the device.
Week: Select "All Week" or "X" according to the day of the week to set
the time for sending alarm emails. Up to two time periods can be set
each day.
Time period1/Time period2: Set the time for sending alarm emails.
E-mail Notification: Check " " to turn on / off when the device alerts
the mail function.
Buzzer Alarm: Check " " to turn on / off the buzzer alarm function.
Record Channel: Check " " to turn on / off the channel recording
function.
Alarm Output: Select the alarm output port, it is connected to the
alarm device, within the set alarm time range, when the device motion
detection alarm, it will trigger an external alarm device to alarm.
Copy: After the channel has been set up, click "Copy" to apply the
setting to another channel.
Coming soon!
When there is a channel losing video signal, the device will alarm and notify
the user.
The specific operation steps are as follows:
Step 1: In the main menu, choose " →Normal Event→Video Loss" to
enter Video Loss interface, as shown in Figure 5-60 below.
To Next Page
Loading...