HeroSpeed NVR - Page 196

195
 Turn on the Set Date/Time Manually; manually select the date and
time, click "Save", the system automatically synchronizes with the
manual setting time.
 Turn on synchronize with the computer, click "Save", the system
automatically synchronizes the time to the computer that logs in to
the WEB page.
 Turn on the Receive date/time from NTP, select NTP server (or
select custom server, enter custom server domain name), select
the device's time zone, enter NTP port, set NTP interval, date
format, date separator, time format, single Click "Save" to
synchronize the system time with the NTP server time.
The date setting parameters are described in the following table:
Parameter
Description
NTP Server
Select the server domain name where the NTP
service is installed.
Custom NTP
server
When the NTP server selects "Custom", enter the
NTP server domain name.
NTP Port
Enter NTP server port.
Date Format
Set the date display format for NVR devices,
including Year Month Day, Month Day Year, Day
Month Year, Day Month Year.
Time Format
Set the time format of NVR devices, including
24-hour and 12-hour.
Date Separator
Set the separator between year, month, and day.
Time Zone
Set the time zone of the NVR device.
Channel Check
Time
Select the NVR channel.
Table 6-2
Set the channel check time as follows:
Step 1: In the main interface, click "Configuration →System →General
→Date" to enter the date setting interface, as shown in Figure 6-18 below.
Steps 2: Select the channel you want to use, or select "All" and click "Save"
to complete the configuration.