Figure 6-36
In the main interface, click "Configuration →System →Smart Event →
Regional Intrusion" to enter the regional intrusion detection setting interface,
as shown in Figure 6-37 below. Here you could set the alarm for regional
intrusion detection. The relevant parameters are consistent with the local
settings of the NVR.
Figure 6-37
In the main interface, click "Configuration → System →Smart Event → People
Stay" to enter the Wandering detection setting interface, as shown in Figure
6-38 below. Here you could set the alarm for people stay detection. The
relevant parameters are consistent with the local settings of the NVR.
To Next Page
Loading...