HIKVISION AXHub - Page 40

You can add two network cameras to the security control panel,
and link the camera with the selected zone for video monitoring.
You can also receive and view the event video via client and
Email.
Add Cameras to the Security Control Panel
Steps
1.
Click System → Network Camera to enter the network camera
management page.
Figure 4-21 Network Camera Management
2.
Click Add , and enter the basic informaon of the camera, such
as IP address and port No., and select the protocol type.
3.
Enter the user name and password of the camera.
4.
Click OK .
5.
Oponal: Click Edit or Delete to edit or delete the selected
camera.
Link a Camera with the Zone
Steps
1.
Click Wireless Device → Zone to enter the
conguraon page.
Figure 4-22 Zone Management
2.
Select a zone that you wish to include video monitoring, and
click the Sengs icon.
3.
Select the Panel Video Channel No..
4.
Click OK.
Set Email to Receive Alarm Video
You can send the alarm video or event to the congured email.
Steps
1.
Click
Communicaon Parameters → Video Vericaon Events
to enter the page.
32