If the opon is enabled, the system will detect all radio
peripherals heartbeat. If no peripherals heartbeat is detected,
the system will upload an event.
Note
For EN, do not switch to OFF.
Forced Arming
If the opon is enabled and there are acve faults in a zone,
the zone will be bypassed automacally.
Note
You should disable the arming funcon in the Advanced
Sengs page. Or the forced arming funcon cannot be valid.
System Faults
If the opon is enabled, the device will upload the system fault
report
automacally.
Disable Funcon Key
If the opon is enabled, all funcon keys will be disabled.
System Volume
The available system volume range is from 0 to 10.
Authority Advanced Sengs
Set advanced authority parameters.
Click System → System
Opons → Advanced Sengs to enter
the Advanced
Sengs page.
You can set the following parameters:
Enable Arming
When you enable the funcon, during the device arming
procedure, the system will check the congured fault checklist.
When there is fault occurred during the arming procedure, the
procedure will be stopped.
Note
PKG keypad and the keyfob do not support this funcon. If this
funcon is enabled, the arming will fail if there is a fault. It is
necessary to eliminate the fault or close the Enable Arming.
Fault Checklist
The system will check if the device has the faults in the
checklist during the arming procedure.
Enable Arming with Fault
Check the faults in the Enable Arming with Fault list, and the
device will not stop the arming procedure when faults
occurred.
Arming Indicator Keeps Light
If the device applies EN standard, by default, the
funcon is
disabled. In this case, if the device is armed, the indicator will
be solid blue for 5 s. And if the device is disarmed, the indicator
will
ash 5 mes.
When the funcon is enabled, if the device is armed, the
indicator will be on all the
me. And if the device is disarmed,
the indicator will be o.
38